Residual determination and risk assessment of buprofezin in plum (Prunus domestica) grown in open‐field conditions following the application of three different formulations

This study was conducted to characterize the residual level and perform a risk assessment on buprofezin formulated as an emulsifiable concentrate, wettable powder, and suspension concentrate over various treatment schedules in plum (Prunus domestica). The samples were extracted with an AOAC quick, easy, cheap, effective, rugged, and safe, ‘QuEChERS’, method after major modifications. As intrinsic interferences were observed in blank plum samples following dispersive‐solid phase extraction (consisting of primary secondary amine and C₁₈ sorbents), amino cartridges were used for solid‐phase extraction. Analysis was carried out using liquid chromatography with diode array detection and confirmed by liquid chromatography–tandem mass spectrometry. The method showed excellent linearity with determination coefficient (R² = 1) and satisfactory recoveries (at two spiking levels, 0.5 and 2.5 mg/kg) between 90.98 and 94.74% with relative standard deviation (RSD) ≤8%. The limit of quantification (0.05 mg/kg) was considerably lower than the maximum residue limit (2 mg/kg) set by the Codex Alimentarius. Absolute residue levels for emulsifiable concentrates were highest, perhaps owing to the dilution rate and adjuvant. Notably, all formulation residues were lower than the maximum residue limit, and safety data proved that the fruits are safe for consumers. Copyright © 2016 John Wiley & Sons, Ltd.     

超声悬浮共聚法制备聚合物微球及其形态

采用超声粉碎和悬浮聚合法,以甲基丙烯酸甲酯、苯乙烯为主单体,过氧化苯甲酰为引发剂,颜料黄74为着色剂,合成了彩色聚合物微球。光学显微镜以及扫描电镜的观察和分析表明：利用超声粉碎法可使聚合物微球的粒径从几百微米降低到几微米;热熔融后,聚合物微球内包覆了细小的颜料颗粒。     

中温热解焦油重馏分悬浮床加氢裂化的研究

以中温热解煤焦油为原料,对其性质进行了分析,其中,350℃重质馏分中胶质含量30.88%,沥青质含量37.27%,四氢呋喃不溶物3.36%,属于常规固定床加氢裂化难以直接处理的馏分。合成了一种Mo系超分散催化剂,采用FT-IR、XPS、XRD、SEM和TEM等对催化剂进行了表征,催化剂中含有Mo=O和Mo-S特征结构,活性金属的硫化率为84.34%,在体系中具有优良的分散性,在反应体系内原位分解为超分散MoS_2颗粒;在0.25 t/d连续装置上进行了热解重油悬浮床加氢裂化实验研究,考察了反应条件对产物分布情况和结焦率的影响,得出适宜的反应条件为19 MPa,440℃,催化剂的添加量为300 mg/kg;此条件下石脑油收率24.47%,柴油馏分收率49.71%,结焦率1.32%。     

高效液相色谱-四极杆/飞行时间质谱鉴定阿莫西林克拉维酸钾干混悬剂中的未知组分

采用高效液相色谱-四极杆/飞行时间质谱(HPLC-QTOF/MS)建立了阿莫西林克拉维酸钾混悬剂(ACPS)中未知组分的鉴定方法,以BDS Hypersil C18(4.6 mm×250 mm,5μm)为色谱柱,以乙腈-水(0.1%甲酸)为流动相,流速为1 mL/min。比较了中国药典方法和HPLC-QTOF/MS方法的相关性;利用半制备液相色谱收集未知组分,并在HPLC-QTOF/MS体系中进行定位和确认,确定未知组分在液质体系中的出峰位置和准确分子量;筛查混合空白辅料成分,并通过与标准品比对,利用HPLC-QTOF/MS鉴定ACPS的未知组分为糖精钠。方法可为抗生素药品中未知组分的鉴定提供参考。     

Solid Particle Distribution in Centrifugal Impeller Contactors

The recently developed centrifugal impeller is examined to investigate the solid–liquid mixing in a mechanically agitated contactor. Using the sample withdrawal method, the effects of impeller geometrical parameters, impeller rotational speed (200–700 rpm), solid particle size (500–1100 µm), and solid loading (2–10 vol%) on the degree of homogeneity are studied. The axial and the radial solid concentration profiles and the minimum impeller speed for the complete homogenization are also determined. In comparison with a widely used propeller impeller, considerably higher homogeneity values in lower impeller speeds are obtained (90% homogeneity against 16% homogeneity at 200 rpm at the same conditions). Having also lower power consumption makes this a superior impeller in solid–liquid mixing processes especially in shear-sensitive systems.      

Investigation of dense slurry suspensions with coaxial mixers: Influences of design variables through tomography and mathematical modelling

The coaxial mixers enhance the suspension of concentrated slurries in an agitated reactor. In this research work, the complex slurry suspension and dissemination behavior in a coaxial slurry mixing system (comprised of a close clearance anchor rotating with a low speed and an inner axial impeller rotating with a high speed) was analyzed employing ERT (electrical resistance tomography, a non-intrusive flow visualization technique), and computational fluid dynamics (CFD). The numerical models were validated by comparing the axial solid concentration profiles generated using the ERT data and the CFD simulation results. The influences of various important parameters such as the diameter of the inner axial impeller, the inner impeller type, and the inner impeller spacing on the hydrodynamic characteristics of the slurry suspensions in a coaxial mixing vessel were thoroughly analyzed. The radial and axial velocity profiles of solid particles were generated using the validated mathematical models. The assessment of energy loss due to the solid–solid collisions, the particle–fluid frictions, and the particle–vessel wall collisions was conducted. The evaluation of optimum inner impeller clearance and inner impeller diameter is essential to attain a high degree of solids suspension and dissemination in a coaxial slurry mixing system.     

磁悬浮演示实验仪

应用电磁学理论、机械力学以及电子技术自制了一套磁悬浮演示实验仪.该演示实验仪利用线性霍尔传感器来探测悬浮物体的位移,以达到控制悬浮的目的,添加数码管电压显示电路,定量显示电磁铁的磁性在悬浮过程中随悬浮物位置变化的自动调整,能精确而直观地演示磁悬浮的物理现象.该仪器结构简单、性能稳定、操作方便,能广泛用于课堂演示、课程设...     

Center problem and bifurcation behavior for a class of quasi analytic systems

Results about the study of nonanalytic systems’ center-focus and bifurcations of limit cycles are hardly seen in published references up till now. In this paper, we investigated the problems of determining center or focus and bifurcations for a class of planar quasi cubic analytic systems. The recursive formula to figure out generalized focal values is given, ulteriorly the conditions for four limit cycles from the origin or the point at infinity are obtained and center problems are considered. What is worth pointing out is that we offer a kind of interesting phenomenon that the exponent parameter λ control the non-analyticity of studied system (3.8) in this paper. In terms of nonanalytic differential systems, our work is new.